Populated PCB

Soldering is all done. I tested the board and everything seems to work well. I did discover a little mechanical errors with my board, the ICSP header and IMU are a little too close, and I have to remove the IMU to use the ICSP. Overall I'm quite happy how things turned out. The final board weighs in at 50g.

PCBs Arrived

After patiently waiting 3 weeks, I finally received my PCBs from BatchPCB. These are the first PCBs I have ever sent out to be manufactured. Pricing models, gerber files, board thickness, etc. have always seemed so intimidating but, BatchPCB and a tutorial at SparkFun made the process easy. With shipping, it came out to be less than $50. I just hope it works.

If you noticed in the photo above I received two PCBs but I only ordered one. I've heard this happening with BatchPCB. I'm not really sure if it's an artifact of how they build their panels but I'm not complaining.

Now I'm off to a fun night of soldering all the parts. The board has three ATmega328 that are in TQFP32 packages and since I have never soldered anything with a pitch that small it should be interesting. After watching numerous surface mount soldering tutorials on YouTube it doesn't look to be all that hard.

Here are some more pictures of the board...

Front



Back

Rigol DS1052E Oscilloscope

New equipment! I received my Rigol DS1052E oscilloscope today. I choose this oscilloscope based on the glowing reviews by Dave over at the EEVblog. After I play with it for a while I'll need to post my own review.

I bought it from Amazon because I had a bunch of Amazon gift certificates, but you can find elsewhere.

Using a Complementary Filter to Combat Vibration

This is the data I received from the IMU along the y-axis (pitch). Accelerometer data is in radians and the gyro data is in radians per second. The data points from 0 to 41 are before the motors turned on. 41-89 is the quad tilting left. 89-129 is the quad tilting right. 129- is the quad tilting to the left again.



As you can see the accelerometer data is quite noisy. I tried dampening the vibration using foam underneath the circuit board, but that didn't help much. Looking at the gyro data it is quite smooth in comparison.

So I looked into using filters that combine the accelerometer data with the gyro data. Using the code for a Complementary Filter (thanks to RoyLB). I was able to produce the following results.

First Balance Test

I adjusted the support rig to hold the quadcopter at the left and right arms allowing it to pivot in only one axis. Above is a video after spending 3-4 hours tweaking the code and adjusting the PIDs (I'm still out one motor and I disabled the other motor for testing). It seems to start the balance quite well but begins to destabilized. After some debugging it looks like the receiver chip is receiving some bad signals. Sometime this week I'm going to debug the receiver code to figure out what's happening. I may also try to remove the receiver code for now to see if I can get a stable balance.

Puff!!! There Goes A Motor.

During a firmware upgrade one of the motors started making a very strange noise. After 3-4 seconds a puff of smoke, the motor was dead. Still not sure what happened. Unfortunately that means ordering another one from Hobby City which has the best price but takes at least a week to get here.

First Take-Off

I managed to have a clean take-off and landing. I don't have any of the sensor data mixed in yet just the R/C receiver throttle. I have the quadcopter held down using zip ties. Next step, new rig to get higher and more control over the flight.